0108 Late Model GM-Chevy Power Bleeder Kit

The 0108 GM Power Bleeder works on most late model GM cars and light trucks. The bayonet-type adapter pushes on to the master cylinder reservoir and locks with a twist. Connecting the adapter and bleeding your brakes is simple.

Includes adapter #1108 to bleed your brakes or clutch. Pays for itself the first time you use it.



Fits most late model General Motors vehicles including Cadillac, Corvette, Buick, Chevrolet, GMC, Oldsmobile,Poniac Saturn. Note: For the 2005+ Mustang please order Power Bleeder kit #0118

Adapters included

Part Number Description
MP-1108 1108 Late Model Chevy-GM Power Bleeder Adapter


Manufacturer Motive Products
Mfgr. Part No. 0108
Brake System Compatability Manual, Power, ABS, Traction Control
Brake Fluid Compatibility Dot 3, 4, or 5*
Tank Capacity 1/2 Gallon
Hose Length ~2 feet
Warranty 1 Year Factory Warranty
Instructions General Power Bleeder Instructions

Work on a variety of vehicles?

Motive Products Power Bleeder 0260 XLT Pressure Brake Bleeder

If you work in a shop or on a variety of vehicles consider the 0260 XLT Power Bleeder Kit. The 0260 kit is includes time-saving features and a number of adapters that permit it to fit most vehicles. All at a discounted price.
Check it out...

Three simple steps to a firm pedal

  • Brake Bleeder Steps
    Add brake fluid to the Power Bleeder
  • Brake Bleeder Steps
    Connect master cylinder and pressurize
  • Brake Bleeder Steps
    Open bleed screw & purge old fluid & air


BEFORE YOU START - Before you start bleeding or flushing your brake system, remove the old brake fluid in your master cylinder reservoir with an old, clean, turkey baster or other suction type device and then replace it with fresh fluid. By doing this you'll be certain that the fluid entering the lines is fresh and you'll minimize the amount of new fluid you'll use in order to clean out the old fluid.

CLUTCH - Some clutches have a separate fluid reservoir and are isolated from the braking system. If the reservoir mouth is the same diamter and configuration as the master cylinder then you will attach the Power Bleeder adapter directly to the to the clutch reservoir. If it is not the same size/configuration, you will need a different adapter to bleed the clutch.

Many other clutch systems share the same reservoir or have a slave reservoir off of the brake master cylinder reservoir. To bleed these clutches, you will connect the pressure bleeder to the master cylinder.