0109 Black Label European Brake Bleeder Kit

Black Label version of the European Power Bleeder features a precision-machined aluminum cap designed to fit most European cars. Included is a swivel fitting to ease installation.

$67.46

Application

Fits most European vehicles with a 45mm round, threaded master cylinder cap.

Adapters included

Part Number Description
MP-1109 1109 European Black Label Adapter

Specifications

Manufacturer Motive Products
Mfgr. Part No. 0109
Brake System Compatability Manual, Power, ABS, Traction Control
Brake Fluid Compatibility Dot 3, 4, or 5*
Tank Capacity 1/2 Gallon
Hose Length ~2 feet
Warranty 1 Year Factory Warranty
Instructions General Power Bleeder Instructions

Work on a variety of vehicles?

Motive Products Power Bleeder 0260 XLT Pressure Brake Bleeder

If you work in a shop or on a variety of vehicles consider the 0260 XLT Power Bleeder Kit. The 0260 kit is includes time-saving features and a number of adapters that permit it to fit most vehicles. All at a discounted price.
Check it out...

Three simple steps to a firm pedal

  • Brake Bleeder Steps
    Add brake fluid to the Power Bleeder
  • Brake Bleeder Steps
    Connect master cylinder and pressurize
  • Brake Bleeder Steps
    Open bleed screw & purge old fluid & air

Tips

BEFORE YOU START - Before you start bleeding or flushing your brake system, remove the old brake fluid in your master cylinder reservoir with an old, clean, turkey baster or other suction type device and then replace it with fresh fluid. By doing this you'll be certain that the fluid entering the lines is fresh and you'll minimize the amount of new fluid you'll use in order to clean out the old fluid.

PORSCHE - Some Porsche models have vented master cylinder reservoirs. You will need to pinch the soft vent tube or plug the end BEFORE bleeding. Do not pinch hard lines & don't forget to unplug the line when done bleeding.

MERCEDES - Some Mercedes Models have two hard plastic vent nipples incorporated into the plastic master cylinder. You will need to plug these before bleeding. Just take a short piece of rubber fuel line and and some hose clamps. Put each end of the hose on one each of the nipples. Use the hose clamps to keep them in place. Don't forget to remove the byplass loop you've created when you're done bleeding.

CLUTCH - Some clutches have a separate fluid reservoir and are isolated from the braking system. If the reservoir mouth is the same diamter as the master cylinder then you will attach the Power Bleeder adapter directly to the to the clutch reservoir. If it is not the same size, you will need a different adapter to bleed the clutch.

Many other clutch systems share the same reservoir or have a slave reservoir off of the brake master cylinder reservoir. To bleed these clutches, you will connect the pressure bleeder to the master cylinder.

$67.46
Printer-friendly versionSend to friend